As I mentioned earlier, I have been trying out my Bond Arms Snake Slayer derringer in various holsters for the puprose of determining, for me at least, which are most suitable for carrying this pistol concealed. I have used the following: Remora clipless (and modified with a kydex clip), the Bond Arms driving cross-draw, and the OWB belt clip holsters, and the D.M. Bullard OWB cross draw holster.
 |
| Bond Arms straight clip OWB holster |
 |
| Bond Arms OWB clip |
 |
| Bond Arms Driving Holster |
 |
| Bond Arms Driving Holster thumb break strap |
 |
| Remora (modified) with mag holder and kydex clip |
This has been an excercise in expectations. Before embarking on this analysis, I had pretty well figured that the modified Remora and the Bond Arms driving holsters would come out on top. But, as with many assumptions and expectations, this did not prove out to be so. The short version - details to follow - is that, for me, the best concealed OWB carry holster is the D.M. Bullard cross draw. By a big margin. For IWB carry, the Remora with attached mag pouch, that I modified with a kydex clip and carry either appendix or cross draw, depending on the situation, works best. Strangely, though, I also have a D.M. Bullard IWB holster with belt loop for my SR9c which accommodates the Snake Slayer beautifully. I could also use this one as an IWB option, and sometimes do. Now to details.I found both of Bond Arms holsters to be extremely well made. Beautiful leather and craftsmanship. Nothing at all to complain about with either of them. What knocked them out of contention for me were design decisions, not quality of materials or workmanship. The OWB belt clip holster is plainly not suitable for conclealed carry if the retention strap is left on the holster. Although it is there to 'retain' the gun for OWB carry, it's really not needed for concealed carry, but instead is an additional, and unnecessary, impediment to a reasonably quick draw. If it was a thumb-break strap, then it might be more suitable, but as it is, you must unsnap the strap, then, hoping it doesn't get in between your hand and the grips, grasp the pistol for the draw. Frankly, one could use this holster without the strap and it would retain the pistol just fine, the fit is that good. Also, for concealed carry, this holster must be worn with a long cover garment because the holster rides so low on the belt. It is a fine holser for open carry though and I would recommend it for that without reservation.
The Driving (cross draw) Holster did not fare well as a general concealed carry rig for me. I was surprised at this. I've seen the videos and the photos and know this is an innovative and functional design. For sitting (including in a car, restaurant, at home, etc.) the design is very good, once properly broken in. However, when not sitting - standing, walking about, running, etc. - the holster did not work so well for me.
The Driving Holster had the longest and most difficult break in of the four. The fit was extremely tight. Not unexpected in a good leather holster, but certainly more tight than any other quality leather holster I've used. And I've used more than a few. After a few days of break in using the derringer tightly wrapped in a few layers of kitchen cling wrap, and many insertions and withdrawls from the holster, I got it to the point where it would grudgingly release. The thumb break strap also took a deal of flexing and snapping/unsnapping to attach without a struggle. Attaching the holster to my gun belt with the leather flap and velcro was easy enough, but it would not hold quite tightly enough, nor the end of the flap tuck under, or against, the holster, until the leather flap itself was sufficiently broken in to curl around the holster body and not spring away from it.
Once all that was in readiness, the thumb break and draw were easy enough to surrender to a firm pull, and the flap was attached securely to the belt and holster, I began working on the access and draw technique. The thumb break strap is attached so that it doesn't readily interfere with the draw. The holster securing-flap however, did not hold tightly enough to keep the holster from sliding along the belt until it fetched up against a belt loop and stopped, where I was then able to extract the pistol from the holster. After fooling with this for a while, I found the solution to be a combination of more break-in for the holster so the pistol did not fit so tightly but was on the verge of loose, a tightened belt (which I don't particularly like. It was tight enough to begin with.) and a tighter wrap of the leather flap around the belt, which can only be so tight because of the nature of the velcro securing patch. You can't pull it tighter like you could with a buckle, for example.
With the horizontal carry position, and the need to have a non-tight fit of the gun to the holster, a thumb break is essential, otherwise, the pistol will eventually, if not sooner, fall out of the holster. I don't worry about it discharging due to the rebounding hammer and the single-action design of the gun, but the Snake Slayer is no lightweight. If it lands on your foot, you will certainly know it. Not to mention, so will everyone else in the room.
My other objection to this holster for concealed carry is that it would, in my case at least, being tall and relatively slim, be restricted to times and places where I can wear a very loose shirt, or jacket, vest or some other concealment garment. Even with the horizontal, up front, orientation of this holster, I does not hide very well without a good cover. For me, light shirts and t-shirts are out.
My conclusion is that if one is primarily wanting a driving or sitting holster, the Bond Arms Driving holster will work fine, once properly broken in and used correctly. But for concealed carry, when one is moving around, sitting, standing, bending, and perhaps running, I don't think it is the best choice.
The modified Remora. I attached a black kydex clip where the mag pouch is sewn into the holster. This means it really does not move, which is an issue with Remora clipless holsters, regardless of what many reviews say. If you don't move around much, the cllpless versions are just fine. They basically stay generally where you put them, but, for me, they have moved around, swiveled, rotated and on occasion, depending on where I put them, began to work up and out of my waistband. I think the Remora with attached mag pouch is both a good idea, and, given the almost double surface area, makes for stable and extremely comfortable holsters. I just wanted the extra confidence of the clip, and this has worked out beautifully for me. One kydex belt clip. One chicago screw. One drilled hole. Shazam! An improvement to an already good holster.
The other positive thing about this rig, is that it perfectly fits the Snake Slayer and the mag pouch will hold three .410 shells flat, or you can get four in there in a diamond configuration, which doesn't add enough bulk to impact the concealability of the holster. The other good things are that this rig is inexpensive - under $30 - and can be worn cross draw or appendix carrry (my favorites) and is easily slipped on and off. I have this set up for my LCP as well.
Lastly, but in first place, is the D.M. Bullard OWB cross draw holster. Here are the good points: one of the best made leather holsters on the market today. Exact fit to the pistol to such a degree that it really required no break in. Really. I've had a number of Bullard holsters, and they all were excellent in fit, but they also required a small amount of break in. This one did not. Holds tight, but easy to draw. I'm not sure how this was accomplished, but I'm not complaining. Just the opposite.
The holster secures to the belt with a loop sewn on the back of the holster body and a forward-facing 'wing' of heavy leather for the second belt loop attachment. This serves to keep the holster close against the body and pulled in tightly to keep the butt of the gun from swinging outward. The nice thing about this design is that it does not require another layer of 'reinforcing' leather to be sewn around the holster mouth. It is just not needed. When I wear this one just forward of my hip bone, it tucks right in and disappears under almost any kind of shirt. When I am going into the 'city', I often throw on a light leather western vest over my shirt and that really makes the holster and Snake Slayer disappear.
I have often worn this setup around the house all day under a light sweater or long sleeve t-shirt and not only do others not know it is there, I sometimes am unaware of it as well.
I generally prefer OWB carry when I can and I can say without reservation, that the Bullard cross draw holster is the best I have found for this. It gets high marks in all of the categories:
- Quality
- Comfort
- Concealment
- Retention
- Fit
- Situational - doesn't matter what the situation, sitting, standing, moving about, running, etc. it performs equally well.
Posted with Blogsy
No comments:
Post a Comment